Question: How do I know if my factory amp is blown?

What happens when an amp blows?

In most cases, an amplifier will blow fuses due to internal damage caused by the way it was installed. An amplifier that blows the main power fuse immediately after you turn it on or when the fuse is inserted into the fuse holder is usually damaged in its power supply or output section, and will require serviced.

What can cause an amp to not turn on?

If the remote and power wires both check out okay, the next thing to look for is continuity on the ground wire. If the ground connection is poor, or it isnt connected at all, the amp may fail to turn on or not work very well.

How do you test an amp to see if it works?

One of the quickest ways is to simply touch the power wire from the amp to the positive post of the battery and the ground wire to the negative battery post. If the power light comes on, it can be ascertained that the amplifier has a good circuit board.

How do you fix an amp that wont turn on?

0:001:27Amp not turning on fix - YouTubeYouTube

What do you do when your amp goes into protection mode?

If you find that one pair of speaker wires or one speaker causes the amp to go into protect, disconnect all speakers from the other end of the wires and separate the wires so they cant touch. If the amp still goes into protect, you have a bad speaker wire or the wire is shorted to chassis ground.

How much does amp repair cost?

I would say the average cost of repairing an amp is $125, and the range is $100 - $300.

How do you check a fuse without removing it?

0:001:12check automotive fuses WITHOUT removing them - YouTubeYouTube

Can a blown fuse stop a car from starting?

A blown fuse in the starter circuit could be the cause of a no-start problem. Broken or corroded wiring - Damaged or dirty wires to the battery or to the starter solenoid (or wires that are loose) can prevent sufficient power from reaching the starter.

Why does my amp keep going in and out of protection mode?

If the amp still goes into protect, you have a bad speaker wire or the wire is shorted to chassis ground. If the amp only goes into protect when one particular speaker is connected to the amp, you have a defective speaker. . If you read 10v or more, the amplifier may have a shorted transformer.

Can amplifier be repaired?

Modern audio equipment is built using delicate components that cannot be repaired; instead, they are replaced. Your audio professional will know which ones to replace, where to get them, and how to do the job. Use a clean pencil eraser to clean cable pins on a regular basis.

How do you check a fuse without a voltmeter?

0:305:14How to test a fuse without multimeter!! - YouTubeYouTube

How do you test a fuse box?

Open the box door and turn on the flashlight to inspect the fuses. Look closely at each fuse. The window on a good fuse will be clear. The window on a fuse that has “blown” to cut off the power and protect the circuit will be cloudy black or gray.

What would stop a car from starting?

Top reasons why cars wont startFlat, faulty or dead battery. The batterys usually the main culprit behind issues with starting your car. Starter motor problems. Fuel problems. Electrical or wiring problems. Engine problems. Faulty immobilisers. Alternator problems. Engine intake issues.More items •Aug 27, 2020

Why did my amp go in protect mode?

Some amps go into protect mode if they get too hot, which can prevent a permanent failure. The common cause of overheating is a lack of airflow. If the amp is located underneath the seats, or in another confined space, that may cause it to overheat.

Say hello

Find us at the office

Hostler- Pertzborn street no. 57, 67563 Kigali, Rwanda

Give us a ring

Anterio Ruebush
+29 780 790 988
Mon - Fri, 8:00-17:00

Contact us